Setting up [Trend Monitor]

Set up trend monitor as follows.
Note
Operations of the ProcItem Setting window
  1. In the Edit Flow window, tap [Trend monitor].
    The ProcItem Setting window is displayed.
  2. In the "Item tab" area, tap [Measurement] to specify an expression used for displaying measurement values on the trend monitor.
  3. In the "Item tab" area, tap [Display range] to specify a measurement value range to be displayed on the trend monitor.
  4. In the "Item tab" area, tap [Judgement] to specify judgement conditions for OK and a warning range that should be called attention to before NGs occur frequently.
  5. In the "Item tab" area, tap [Data save] to perform setting and save the data.
  6. In the "Item tab" area, tap [Output parameter] to perform necessary settings.
  7. Tap [OK].
    After confirmation, the ProcItem Setting window will be closed.
  8. Perform a measurement test.
  9. Verify measurement results.
    When NG is displayed, please measure again and make Adjust if necessary.