Setting Up [Scan Edge Width]

The setting procedure for [Scan Edge Width] is as follows:

Note

Operations of the ProcItem Setting window

For the basic operations of the ProcItem Setting window, see User's Manual, "Operations of ProcItem Setting Window".

In the Edit flow window, tap [Scan Edge Width].
The ProcItem Setting window is displayed.
User's Manual, "ProcItem Setting Window"
In the "Item tab" area, tap [Region setting] and specify the measurement region.
[Region Setting (Scan Edge Width)]
In the "Item tab" area, tap [Edge color] to specify the reference color to be detected as the edge.
[Edge Color - for Color Cameras Only (Scan Edge Width)]
Tap [Judgement] in the "Item Tab" area, and set the judgement condition for OK.
[Measurement (Scan Edge Width)]
Important
- If you change an output parameter after setting judgement condition, measurement result changes. When you change an output parameter, reset judgement condition as well.
Tap [OK].
After confirmation, the ProcItem Setting window will be closed.
Perform a test measurement.
User's Manual, "Test Measurement before Actual Operation"
Verify measurement results.
User's Manual, "Display of the RUN Window"
When "NG" is displayed, verify measurement results and make adjustments if necessary.
Points on Test Measurement and Adjustment (Scan Edge Width)