Setting up [Date Verification]

Follow the steps below to set up [Date Verification].

Note

Operations of the ProcItem Setting window

For the basic operations of the ProcItem Setting window, see User's Manual, "Operations of ProcItem Setting Window".

In the Edit Flow window, tap [Date Verification].
The ProcItem Setting window is displayed.
User's Manual, "ProcItem Setting Window"
In the "Item tab" area, tap [Verification] and set the parameters for the verification string.
[Verification (Date Verification)]
In the "Item tab" area, tap [Date parameter] and set the date /time to be compared.
[Date Parameter (Date Verification)]
In the "Item tab" area, tap [Code parameter] and set the code parameter.
[Code Parameter (Date Verification)]
Tap [OK].
After confirmation, the ProcItem Setting window will be closed.
Perform a test measurement.
User's Manual, "Test Measurement before Actual Operation"
Verify measurement results.
User's Manual, "Display of the RUN Window"
When "NG" is displayed, verify measurement results and make adjustments if necessary.
Points on Measurement Test and Adjustment (Date Verification)