[Output Parameter (3D Search)]
Specify how to treat the coordinates to be output to the external device as measurement results.
Important
- After setting up the measurement parameters, changing the output parameters will cause measurement results to vary accordingly. If the output parameters have been changed, re-specify the measurement parameters, too.
- In the Item Tab area, tap [Output parameter].
- Specify a value for each item.
Table:
Setting Values for Output Parameters
|
Set Value [Factory default]
|
|
World geometric transformation
|
|
Select whether to output measurement results to external devices whether in coordinates converted to the actual size (World geometric transformation: ON) or by converting them into the coordinates of camera image (World geometric transformation: OFF).
|
Reflect to overall judgement
|
|
Select whether to reflect the judgement result of this processing unit to the overall judgement of the scene.
- Selecting [ON] reflects the judgement result of this processing unit on the overall judgement of the scene.
- Selecting [OFF] does not reflect the judgement result of this processing unit on the overall judgement of the scene.
|
Note- For world geometric transformer, see
User's Manual, "Configuring 3D measurement".
- The overall judgement result of the scene is output to the OR signal to be sent via the parallel interface. Also, it is displayed in the Measurement Information Display area in the upper part of the Main screen.
Back
Processing Items List Manual
Processing item List > Chapter 3 - Inspection and Measurement > 3D Search > [Output Parameter (3D Search)]
Top