[Output Parameter (Label Data)]

[Output Parameter (Label Data)]

Selects the options for the measured results, namely the coordinates, which are output to the external devices.

Important

After setting up "Judgement condition" in [Setting], changing the output parameters will cause measurement results to vary accordingly. If the output parameters have been changed, set up "Judgement condition" again.

In the "Item tab" area, tap [Output parameter].

Specify a value for each item.

Output Parameter - Detail Area

Table: Setting Values for Output Parameter
Setting Options	Set Value [Factory defaults]	Description
Output Coordinate	[After scroll] Before scroll	Select whether to output measured results to external devices before or after the position deflection correction is applied.
Calibration	[OFF] ON	Select whether to output measurement results to external devices by converting them into the coordinates with actual size (calibration: ON) or into the coordinates of camera image (calibration: OFF).
Reflect to overall judgement	[ON] OFF	Select whether to reflect the judgement result of this processing unit to the overall judgement of the scene. Selecting [ON] reflects the judgement result of this processing unit on the overall judgement of the scene. Selecting [OFF] does not reflect the judgement result of this processing unit on the overall judgement of the scene.

Note

For output coordinates and calibration, see User's Manual, "Configuring Coordinates".
The overall judgement result of the scene is output to the OR signal to be sent via the parallel interface. Also, it is displayed in the "Measurement information display" area in the upper part of the Main screen.
User's Manual, "Time Chart"
User's Manual, "Main Screen (ADJUST window)"

For the subsequent operations, see

Setting up [Label Data].