Points on Measurement Test and Adjustment (Search)

In addition to the camera-input image, the registered model and the detection coordinates (the cross-shaped cursor) will also be displayed in the "Image display" area.

In the "Detail result" area on the Main screen, you can confirm the following contents in text.

User's Manual, "Displaying Flow and Detail Result"

Table: Text Displayed (Search)
Item	Description
Judge	Judgement result
Correlation	Correlation
Measure X	X coordinate of the position where the model is detected
Measure Y	Y coordinate of the position where the model is detected
Correlation	Angle of the position where the model is detected

Points on Adjustment

Please choose your Adjust methods as follows.

When search fails (searching other positions)

To improve the search accuracy, the following Adjust should be made to measurement parameters.

Specify a larger value for [Prec.].
Changing [Model Parameter]
Check the "Sub-pixel" option.
[Measurement (Search)]

When the processing speed is slower

Reduce the measurement region size in [Region Setting].
[Region Setting (Search)]
Reduce the region registered in the model in [Model].
[Model (Search)]

In addition, adjust other options in the "Model parameter" area of [Model].

Points on Adjustment

When the judgement is NG (insufficient memory)

Reduce the measurement region size in [Region Setting].
[Region Setting (Search)]

Reduce the amount of information necessary for measurements by making the following adjustment in the "Model parameter" area of [Model].

Set "Stab." or "Skipping angle" to a value closer to the factory default.
Specify a smaller value for "Prec.".
Changing [Model Parameter]

Note

If lowering "Stab." leads to slower processing, it is likely that many candidates have been detected. In this case, specify a larger value for "Candidate LV" or "Stab.".