[Output Parameter (Search)]
Select options for the measured results, namely the coordinates, which are output to the external devices.
Important
- After setting up the measurement, changing the output parameters will cause measurement results to vary accordingly. If the output parameters have been changed, re-specify the measurement, too.
- In the "Item tab" area, tap [Output parameter].
- Specify a value for each item.
Table:
Setting Values for Output Parameter
|
Set Value [Factory defaults]
|
|
|
- [After scroll]
- Before scroll
|
Select whether to output measurement results to external devices before or after the position deflection correction is applied.
|
|
|
Select whether to output measurement results to external devices by converting them into the coordinates with actual size (calibration: ON) or into the coordinates of camera image (calibration: OFF).
|
Reflect to overall judgement
|
|
Select whether to reflect the judgement result of this processing unit to the overall judgement of the scene.
- Selecting [ON] reflects the judgement result of this processing unit on the overall judgement of the scene.
- Selecting [OFF] does not reflect the judgement result of this processing unit on the overall judgement of the scene.
|
Note- For output coordinates and calibration, see
User's Manual, "Configuring Coordinates".
- The overall judgement result of the scene is output to the OR signal to be sent via the parallel interface. Also, it is displayed in the "Measurement information display" area in the upper part of the Main screen.
Back
Processing Items List Manual
Processing item List > Chapter 3 - Inspection and Measurement > Search > [Output Parameter (Search)]
Top