Skip headerBackNext
User's Manual
 Environment Setting Part > Chapter 10 - How To Connect & Communicate With External Devices > Serial Interface > Instruction Specification (Serial Interface)

Instruction Specification (Serial Interface)

This section explains an example of the command input format that is used in the Serial Normal method.
Communication specifications will be decided based on Setting Communication Specifications (Serial Interface).
Example of Input Format (SCENE Command)
SCENE<Scene No.>
 delimiter 
  • Set up the parameter value in < >.
  • Parameters are separated by space. (not required before  delimiter )
  • Delimiters must be input at the end of commands.
  • The following are Errors. When Errors occur, the system will be quitted.
    • When non-existing commands are used
    • The number of parameters is incorrect
    • The scope of parameters is incorrect
    • The content of parameters is incorrect
    • Can not quit correctly when executing the action commands
Important
  • Commands can be inputted and measurement results can be outputted only when the Main screen is at the foremost front. Cannot react to commands when setup windows or the Edit flow windows are displayed (not including "Serial" - "Confirmation"). In the Main screen, the output data after measurement will not be interrupted to the last one, even when the Main screen is switched to the Edit Flow window, etc. Can not react to commands when windows other than the Main screen are displayed.
Top
BackNext
Copyright© 2007 OMRON Corporation All Rights Reserved.