Saving Settings and Powering Off

Before turning off the power of the controller, perform the following operations to save the scene data that you have set. Scene data of Scene Group 0 will be Saved into the built-in flash memory of controller. If USB memory is inserted, the setting data of Scene Group 1 to 31 will be Saved into USB memory.
Whenever starting up, the controller loads the scene data from the flash memory. Therefore, if you turn off the power without saving the data to the flash memory, the changes made will not be retained.

Important

Logged images in the controller and images/data saved on the RAM Disk are deleted when the power is turned off, since they cannot be saved in the flash memory. If you want to keep these images or data, perform either of the following procedures.
- In "Logging setting", set the Destination folder to the USB memory.
  Setting up Logging Condition [Logging setting]
- In "Save to file", copy the data saved to the RAM Disk to the USB memory.
  Copying/Moving File [Save to file]

On the Main screen (the ADJUST window), tap [Data save] in the Toolbar to save the set data.
For details on this operation, see Saving Setting Data in the Controller's Memory [Data save].
Exit after powering off controller.