Instruction Specification (Ethernet Connection)

This section describes the examples of command input format in the Ethernet normal method.

Communication specifications will be decided based on

The input format and serial port are basically the same.

But no delimiter is needed at the end of the commands with the no-order mode of the Ethernet connection.

For continuous data transmission, the space (0x20) is used to separate two adjacent data, which is used as a packet to transfer.

Command	:	DISPCOND
Response	:	View State OK

Important

With Data Output (setting for Ethernet output), up to 128 units can be registered. Note, however, that all the data may not be received depending on the environment you use (network environment, PC's performance, software to receive data, etc.).