[Camera N: White Balance (3D Camera Image Input)]
Set up the white balance to make white objects look white by calibrating the color of images scanned from cameras.
By adjusting the white balance, the white color can be appropriately reproduced under any lighting conditions
Appropriate value can also be set automatically.
Note- Perform the white balance setting only when a color camera is used.
- Be sure to perform the white balance setting in the following cases:
- When a new system is installed
- When a camera or lighting is changed
Since measurement results may vary with changes of the white balance setting, be sure to verify the operation after it has changed.
- In the "Item tab" area, tap [White balance].
- In the "White balance setting" area, specify "R", "G", and "B" values.
Whiteness increases when the value of "R", "G", and "B" is increased.
Table:
White Balance Setting (3D Camera Image Input)
|
Set Value [Factory Default]
|
|
|
0.001 to 7.999 (for each of "R", "G", and "B") For FZ-SC connection: [R=1.183] [G=1.000] [B=1.323] For FZ-SC2M connection: [R=1.394] [G=1.000] [B=1.222]
|
Adjust the white balance.
|
Setting optimum values calculated automatically:
Display the white area in the center of the screen and tap [Auto].
The white color displayed in the center of the screen is identified as "white" and white balance is set automatically to match this.
When adjusting the values manually
Specify the RGB values to be processed as white.
Drag the slider while verifying the image in the "Image display" area.
After the automatic setting, individual fine-tuning can still be performed.
Tap the buttons at both ends of the slider.
Back
Processing Items List Manual
Processing item List > Chapter 1 - Image Input > 3D Camera Image Input > [Camera N: White Balance (3D Camera Image Input)]
Top