Filter Setting (Halation Suppression+)

Filter Setting (Halation Cut+)

This item sets the filter.

In the Item Tab area, tap [Filter Setting].

In the "Display" area, tap [Change display] to switch between camera image types.

The displayed contents of the Image Display area will be switched.

Setting item	Set value [Factory default]	Description
Display	Through image display	The latest image is always input from the camera and displayed.
Display	[Freeze image display]	The image that was scanned in the immediately preceding measurement is displayed.

Set each item in the "Filter parameter" area.

Filter setting - "Filter param" area

Setting item	Set value [Factory default]	Description
RGB ratio	-100 to 100 [0]	Adjust the balance of the red brightness and blue brightness for the shot image. Specifying a larger value in the positive direction (R direction) makes the R component easier to suppress. Specifying a larger value in the negative direction (B direction) makes the B component easier to suppress.
Gain	0.0001 to 9.9999 [1.0000]	Adjust the gain for compensating the brightness of the output image.

As necessary, check the image after conversion.
Setting item
Set value
[Factory default]
Description
Filtered image
[Checked]
Unchecked
To display the original image, uncheck here.