Calibration (Calibration+)

Sets the calibration method.

Specifying Points and Setting (Point Specification)

This is a method for performing calibration by specifying arbitrary points (in pixels).
Input the actual coordinates for the specified position.Up to 9 points can be indicated.

In the "Calibration setting" area, select "Point coordinate".
Tap the first point on the screen.
Input the actual coordinates for the specified point.
The actual coordinate input window is displayed.
Actual coordinate
Set value
[Factory default]
Point coordinate X, Y
0.0000 to 9999.9999
[Point you tapped in the window]
Actual coordinate X, Y
-99999.9999 to 99999.9999
[0]
Subsequently set up in the same manner.
Tap [Generate calibration parameters].
The calibration parameters will be generated.
- If this succeeds,
  the Calibration parameter status changes from "The parameter is not generated" to "The parameter is the latest".
- If this fails,
  "Failed to generate parameters" is displayed.

Actual coordinate	Set value [Factory default]
Point coordinate X, Y	0.0000 to 9999.9999 [Point you tapped in the window]
Actual coordinate X, Y	-99999.9999 to 99999.9999 [0]

Setting Calibration through Sampling Measurement (Sampling)

This is a method for setting calibration based on measurement results.
Calibration parameters are calculated automatically when a registered model is searched and the actual coordinates for that position entered.

In the "Calibration setting" area, select "Sampling".
In the "Sampling" area, tap [Regist model].
Use the Drawing tools to register the model.
Adjust the search region as necessary.
Tap [Sampling measurement].
Measurement is performed.
The search result (cross-shaped cursor) is displayed in the Image Display area, and the Sampling coordinate input window is displayed.
In the Sampling Coordinate window, enter the X and Y values.
Tap [OK].
Point coordinates and actual coordinates are registered in the "Sampling" area.
Move the object to be measured and repeat the Steps 2 to 7.
Tap [Generate calibration parameters].
The calibration parameters will be generated.