Filter Setting (Stripes Removal Filter+)

This item sets the filter.
  1. In the Item Tab area, tap [Filter Setting].
  2. In the "Display mode" area, tap [Change display] to switch between camera image types.
    Striped pattern suppression+ - "Display" area
    The displayed contents of the Image Display area will be switched.
    Setting item
    Set value
    [Factory default]
    Description
    Display mode
    Through
    The latest image is always input from the camera and displayed.
    [Freeze]
    The image that was scanned in the immediately preceding measurement is displayed.
  3. Set the target image.
    Striped pattern suppression+ - "Target image" area
    Setting item
    Set value
    [Factory default]
    Description
    Target
    Camera image
    The camera input image that has not been subject to filtering is subject to compensation as is.
    Images to which processing is applied in units even before the "Stripes Removal Filter+" being set are the targets.
  4. This sets the filter settings.
    Striped pattern suppression+ - "Filter setting" area
    Setting item
    Set value
    [Factory default]
    Description
    Defect brightness
    • [Light]
    • Darkness
    • Light and darkness
    Set the brightness of defects to be extracted from the background.To detect both white defects and black defects, select "Light and darkness".
    Pattern kind
    • [Normal pattern]
    • Vertical stripes
    • Horizontal stripes
    • Cross stripes
    Select the pattern design to be eliminated as background.
    Normal: Used to eliminate patterns without the specified pattern.The pattern eliminated must be adequately larger than the defect to be extracted.
    Vertical stripe: Vertical stripe patterns are eliminated.
    Horizontal stripe: Horizontal stripe patterns are eliminated.
    Grid: Grid patterns are eliminated
  5. Set the details.
    Pattern kind: "Normal pattern", "Vertical stripes", or "Horizontal stripes"
    Striped pattern suppression+ - "Detail" area
    Setting item
    Set value
    [Factory default]
    Description
    Defect size
    3 to 63
    [3]
    Specify a larger value to match the size of the defects to be extracted.
    Gain
    1 to 63
    [3]
    Adjust the contrast of an image after the pattern suppression.
    Specifying a larger value emphasizes the density differences within the image.
    Pattern kind: "Cross stripes"
    Striped pattern suppression+ - "Detail" area
    Setting item
    Set value
    [Factory default]
    Description
    V filter size
    3 to 63
    [21]
    Set the grid pattern vertical direction width.
    Only for "Pattern kind" of grid
    H filter size
    3 to 63
    [21]
    Set the grid pattern horizontal direction width.
    Only for "Pattern kind" of grid
    Background pattern
    • [Checked]
    • Unchecked
    Place a check here if there is yet another pattern to eliminate within the grid pattern.
    Only for "Pattern kind" of grid
    S filter size
    3 to 63
    [3]
    Match this size to the size of the pattern you want to eliminate from within the grid pattern.
    Gain
    1 to 63
    [3]
    Adjust the contrast of an image after the pattern suppression.
    Specifying a larger value emphasizes the density differences within the image.