Output Parameters (Character Inspection)

Specify how to treat the coordinates to be output to the external device as measurement results.
Important
  • After setting up the measurement parameters, changing the output parameters will cause measurement results to vary accordingly.If the output parameters have been changed, re-specify the measurement, too.
  1. Tap [Output parameter] in the "Item tab" area.
  2. Specify a value for each item.
    Output parameter - "Detail" area
    Setting item
    Set value
    [Factory default]
    Description
    Reflect to overall judgement
    • [ON]
    • OFF
    Select whether have the judgement result of this processing unit reflected in the overall judgement of the scene.
    Character output
    Character output
    • [Unchecked]
    • Checked
    Specify whether to output read-in character strings to an external device.
    The output parameter character output function is only enabled when the communications module selection is non-procedure.
    When the communications module selection is set to PLC Link, this function is ignored.
    Output Destination
    • [RS-232C/RS-422]
    • Ethernet
    When "Character output" is checked (output), this specifies the device to which strings are output.Character strings are output as ASCII code character strings. When kanji or other characters that are not ASCII codes are included, they are not output correctly.