Measurement Parameters (Flexible Search)

Measurement Parameters (Flexible Search)

Specify the search measurement conditions and the judgement conditions for the measurement results.

In the "Item tab" area, tap [Measurement].

In the "Measurement condition" area, specify a value for each item.

Measurement - "Measurement condition" area

Setting item	Set value [factory default]	Description
Sub-pixel	Checked [Unchecked]	When a check is placed at sub-pixel, the position information can be measured in units of sub-pixels.However, this requires more processing time.
Candidate Point Level	0 to 100 [70]	Specify the threshold value with which to detect candidate points in a rough search.Specify a smaller value when model search results are unreliable.

When the setting has been changed, tap [Measure] in the "Detail" area to verify whether measurements can be made correctly.

Set up the judgement condition.

Measurement - "Judgement condition" area

Note

The values beside each item are measurement results of the displayed image.Take these values into consideration to determine the upper and lower limits.

Setting item	Set value	Description
Measure X	-99999.9999 to 99999.9999	Specify the range of X-axis shifting that is judged to be OK.
Measure Y	-99999.9999 to 99999.9999	Specify the range of Y-axis shifting that is judged to be OK.
Measure angle	-180 to 180	Specify the range of angles that are judged to be OK.
Correlation value	0 to 100	Specify the range of correlation values that are judged to be OK.However, when the correlation value of the measurement result is 0, the judgement result will be NG regardless of the lower limit setting.